Beijer-electronics iX Panel T100 EN Instrukcja Użytkownika Strona 24

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 46
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 23
Hardware Replacement
8.4 ReplacingtheDisplay/Display
Cable
The following is needed:
A ne w display/display cable, see Available Spare Parts for iX Panel T100
AtorxT10screwdriver
Note:
MakesuretouseadequateESDprotection.
Follow the steps below to replace the display/display cable:
1.
Power off the operator panel.
2.
Follow the instructions under Replacing the Rear Cover to remove the rear
cover.
3.
Disconnect the two ex cables the flex cable and the LED cable from the
power card and remove the two plastic nuts that h old the power card in place.
LED cable
plastic nut
flex cable
plastic nut
4.
Lift the power card and gently remove the backlight cables and the display
cablefromtherearsideofthepowercard.
display cable
backlight cables
BeijerElectronics, MAEN007
24
Przeglądanie stron 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 45 46

Komentarze do niniejszej Instrukcji

Brak uwag