Beijer-electronics iX Panel T70 EN Instrukcja Użytkownika Pobierz pdf (Strona 29)

Service Menu

9ServiceMenu

The service menu for the operator panel can be accessed before a project is

downloaded, or by setting the mode switches in mode 1000. The location of the

mode switches is described in the Mode Switches section.

9.1 ServiceMenuinanEmptyPanel

When no project is loaded in the panel memory, the panel will boot, displaying the

Welcome screen. Press anywhere on the panel display to enter the service m enu.

9.2 ServiceMenuinaPanelwith

Project

When a project is loaded in the panel memory, the panel will automatically start to

execute the project. To display the service menu at boot-up:

Disconnect the power supply from the panel.

Set the mode switches in mode 1000 (Service Menu mode).

Connect the power supply.

When the panel boots up it will suggest to go into the Touch Calibrate mode.

This ensures t hat it will be possible to recover from a bad calibration.

Press anywhere on the panel display to interrupt the timer and to enter the

service menu.

Make desired settings in t he service menu.

Disconnect the power supply from the panel.

Set the mode switches in mode 0000 (Run mode).

Reconnect the power supply.

9.3 ServiceMenuOptions

The following options are available in the Service Menu:

9.3.1 IPSettings

Select to obtain an IP address automatically via DHCP, or specify an IP address.

The IP address can also be set during project transfer.

9.3.2 Date/Time

Use the Date/Time Settings dialog to set the time zone, date and time for the

panel.

BeijerElectronics, MAEN006

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 45 46

Brak uwag

Beijer-electronics iX Panel T70 EN Instrukcja Użytkownika Strona 29