Beijer-electronics iX Panel TA150 EN Instrukcja Użytkownika Pobierz pdf (Strona 23)

Hardware Replacement

Remove the mounting plate (12 torx screws). Gently lift the mounting plate

with the display and power card.

12 x torx screws

Flip the mounting plate and unscrew the 4 torx screws, located on front or

side.

4 x torx screws

Re-assemble the panel in reverse order.

7.4.1 SelfTestoftheDisplay

To perform a self test of the display, follow the steps below:

Start the operator panel in a self test mode (see table in the Mode Switches sec-

tion).

Go to the display test, by running or skipping the preceding tests. Verify that

the display works.

If the screen does not work, try fault tracing, see the Fault Tracing section.

7.4.2 CalibratingtheTouchScreen

Follow the steps below to calibrate the touch screen:

Set the M ODE switches to the correct positions in order to enter the Service

Menu mode (see table in the Mode Switches section).

Switch on the power an d follow the instructions.

Power off the operating pa

nel.

Reset all MODE switches to the OFF position.

BeijerElectronics, MAEN014A

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 44 45

Brak uwag

Beijer-electronics iX Panel TA150 EN Instrukcja Użytkownika Strona 23